PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : Creative X-Fi mit Intel Hd-Audio Anschlüssen,


Gast
2006-11-20, 20:53:21
Ich habe eine Creative X-Fi Extreme Gamer mit einem internen Intel HD-Audio Anschluss, mein Gehäuse verfügt aber über AC97 Front Anschlüsse, von den Pins her würde es passen, aber ich glaube die Pin-Belegung ist anders? Wer kann mir zeigen wie ich die Kopfhörer/Mic Anschlüsse richtig verbinde?
Danke

Avalox
2006-11-20, 21:34:57
Das sollte die Belegung sein.


Pin Signal Name Description
1 PORT 1L Analog Port 1 - left channel (Microphone)
2 GND Ground
3 PORT 1R Analog Port 1 - right channel (Microphone) 4 PRESENCE# Active low signal that signals BIOS that an Intel HD Audio dongle is connected to the analog header. PRESENCE# = 0 when an Intel HD Audio dongle is connected
5 PORT 2R Analog Port 2 - right channel (Headphone) 6 SENSE1_RETURN Jack detection return for front panel (JACK1)
7 SENSE_SEND Jack detection sense line from the Intel HD Audio CODEC jack detection resistor network
8 KEY Connector Key
9 PORT 2L Analog Port 2 - left channel (Headphone)
10 SENSE2_RETURN Jack detection return for front panel (JACK2)

Gast
2006-11-20, 21:57:21
Das sollte die Belegung sein.


Pin Signal Name Description
1 PORT 1L Analog Port 1 - left channel (Microphone)
2 GND Ground
3 PORT 1R Analog Port 1 - right channel (Microphone) 4 PRESENCE# Active low signal that signals BIOS that an Intel HD Audio dongle is connected to the analog header. PRESENCE# = 0 when an Intel HD Audio dongle is connected
5 PORT 2R Analog Port 2 - right channel (Headphone) 6 SENSE1_RETURN Jack detection return for front panel (JACK1)
7 SENSE_SEND Jack detection sense line from the Intel HD Audio CODEC jack detection resistor network
8 KEY Connector Key
9 PORT 2L Analog Port 2 - left channel (Headphone)
10 SENSE2_RETURN Jack detection return for front panel (JACK2)

Also schliesse ich nur die Signal-Ton-Leitungen an, die restlichen Detect-Anschlüsse werden nicht belegt, daher würde eine automatische Erkennung nicht stattfinden, was nicht vom Nachteil ist ;-)
Müsste ja manuell hoffentlich über Software aktivierbar sein, oder auch ständig offen?
Also, jetzt muss nur noch das neue Mainboard kommen, dann teste ich die X-Fi Gamer mit Front AC97.